T12-24
Push button timer for LED strips from 12V to 24V (DC)
LED push button timer with 12VDC to 24VDC power supply. Ideal for 12V or 24V DC strips or LED lamps. It supports an unlimited number of buttons connected in parallel (without indicator light). Adjustable from 3 seconds to 10 minutes. Restartable at any time.
COMPATIBLE WITH ANY LED FROM 12VDC TO 24VDC
Installation scheme
4-wire installation. Connect Positive of the source to terminal 1 and Negative of the source to terminal 2. In terminal 3 connect the negative of the LED strip or lamp and the positive of the LED directly to the positive of the source. Finally, at terminal 4 connect one of the poles of the push-button / s, whose opposite pole comes from the negative of the source.
Download the product data sheet
For more details of characteristics, operation, control, installation diagram, admissible loads, maximum admissible power, etc. You can view and download the product data sheet by clicking on the button below.
Low voltage timer
For installations where 230V alternating voltage is not available, such as boats, vehicles, etc. In LED strip installations, it is installed between power supply and LEDs.
Functioning
With each press, the ignition is activated and the timing established in its setting begins. If pressed while on, the timing restarts.
Up to 8A of charge
Supports up to a maximum of 8A of charge. If the installation is at 12VDC it would be a maximum of 96W. On the other hand, if the installation is at 24VDC, the maximum is 192W of load.
Let's talk...
If you still have any questions, write us: